Planet IGS-10020 Series User Manual page 48

2. Tighten the wire-clamp screws for preventing the wires from loosening.
Model Name
IGS-10020MT
IGS-10020PT/HPT
IGS-10020HPT
IGS-10080MFT
IGS-12040MT
IGS-20040MT
IGS-20160HPT
1. The wire gauge for the terminal block should be in the range of 12 ~ 22 AWG@25 degrees C.
2. When performing any of the procedures like inserting the wires or tightening the wire-clamp screws,
make sure the power is OFF to prevent from getting an electric shock.
1 2 3
DC 1
Figure 2-20 6-Pin Terminal Block Power Wiring Input
Positive (+) Pin Negative (-) Pin
Pin 2/6 Pin 1/5
Pin 1/6 Pin 2/5
Pin 1/5 Pin 2/6
Pin 1/5 Pin 2/6
Pin 1/5 Pin 2/6
Pin 1/5 Pin 2/6
Pin 1/5 Pin 2/6
48
4 5 6
DC 2
Input Voltage
DC 12~48V, AC 24V
DC 48V
DC 48V
DC 12~48V, AC 24V
DC 12~72V, AC 24V
DC 9~48V, AC 24V
DC 48~56V, AC 24V
User's Manual