Upgrading Software - Bard Site-Rite 6 Instructions For Use Manual

28
Site~Rite * 6 Ultrasound System

8 Upgrading Software

The Site~Rite* 6 Ultrasound System allows the software to be upgraded through the USB connectors located
on the rear of the scanner.
To install software:
1. Press the Freeze button (
2. Insert the USB drive containing the software upgrade into one of the USB connectors located on the
rear of the Site~Rite* 6 Ultrasound System scanner.
3. Wait until the storage device icon is illuminated before proceeding.
4. Simultaneously press and hold the Gain buttons (
5. When the configuration screen appears, simultaneously press and hold the Depth button ( cm ) and
Depth Marker button (
Note: The Site~Rite* 6 Ultrasound System will automatically upload the software from the attached
USB drive.
Note: The screen may appear blank and/or inactive during part of the software installation process.
6. When the system displays a message that the software update is successful, power off the Site~Rite* 6
Ultrasound System scanner.
7. Disconnect the USB drive.
8. Power on the Site~Rite* 6 Ultrasound System scanner.
9. Verify that the correct software version appears on the upper left hand corner of the screen.
10. Resume normal operation.
) to pause the system.
/:\ ) until the software installation process begins.
) until the configuration screen appears.
,