Connecting And Disconnecting Site~Rite * 6 Ultrasound System Probe - Bard Site-Rite 6 Instructions For Use Manual

2.4
Connecting and Disconnecting the Site~Rite * 6 Ultrasound System Probe
1.
Warning: Use only Bard Access Systems probes with this system. Use of unapproved probes may result in patient
injury or equipment damage.
Caution: Do not pull the cable to disconnect the probe connector from the scanner. Pulling the cable may
damage the cable, cable connection or scanner.
Caution: Do not twist or bend the probe cable in excess of that required during normal use of the probe.
Excessive twisting or bending of the cable may cause failure, intermittent or unpredictable operation.
2.5
Powering on the Site~Rite
To power on the Site~Rite
1. Verify that the probe is connected to the Site~Rite* 6 Ultrasound System scanner.
2. Depress and release the power button located on the front of the Site-Rite* 6 Ultrasound
System scanner.
3. Wait approximately 20 seconds for the display screen to illuminate.
4. To power off the Site~Rite* 6 Ultrasound System, depress and release the power button
again. The system is powered off when the display screen darkens.
2.
*
6 Ultrasound System
6 Ultrasound System
*
Instructions For Use
3.
15