Download Print this page

Install Batteries - Kohler BARDON VITREOUS CHINA TOUCHLESS K-4915T-Y Installation Instructions Manual

Advertisement

B. When installing the power uint on the ceiling,please
layout bushing according to Fig.#9 and thread wire through
the bushing.
Fig.#9: Connection sketch while installing power uint on the
ceiling.
CAUTION: One AC power unit can supply two sensors
at most.
B. 将电源盒放在天花板上,如图示安装电工套管,管
内装入电线。
图9:交流电源盒安装在天花板上的连接示意图。
警告:一个交流电源盒最多可连接两个感应区。
Notice:
a. Keep the connector away from water.
b. Don't mistake the direction of inlet and outlet.
c. Do not connect the DC output of AC power unit to AC
power supply.
d. Do not connect to power supply while installing. Connection
line is not supplied. AC connection wire with insulating
sleeving is recommended. Wire of which the nominal sectionn
area of conductorisnot less than 0.5mm
DC connection line use wire of which the nominal section area
is not less than 0.3mm
requirements (The length of cut wire is recommended less than
10m).
e. The head AC power supply must be protected with
appropriate fuse.
f. Please confirm the AC power supply and water supply should
be shut off before maintaining the products with AC power
related.

3. INSTALL BATTERIES

See Fig.#10
Turn on stop valve. Inspect pipes for leakage in not flushing.
Connect the connector of sensor window with the connector
of solenoid valve.
Remove the battery box cover and insert alkaline batteries
into the battery box.Reinstall the cover of the baottery box
and tighten it with battery box with screws. Connect the
connector of battery box with the connector of the sensor
window.
See the section "Replace Batteries".
NOTE: Do not lose the screws when removing the
cover of battery box. Tighten the screw, otherwise the
batteries may be affected with damp.
6
2
is also recommend.
2
. It is cut according to acted installation
(Only for DC)
注意:
a. 不要让电线接插件接触水。
b. 不要将进出水方向弄错。
c. 不可将交流电源盒的直流输出端与交流电连接。
d. 安装时不要向电源盒供电。连接线请用户自备,建
议交流电源线采用导体标称截面积≥0.5mm
直流连接线采用导体标称截面积≥0.3mm
电线长度根据实际安装需要自行裁剪(建议连接线
长度小于10m)。
e. 交流电的总电源必须有合适的熔断丝加以保护。
f. 维修时必须断开交流电源并关闭水源。
Fig. #10
图10
AC Power Unit
Ceiling
交流电源盒
天花板
Bushing
电工套管
Fig. #9
图9
2
的电线,
2
的电线,
1146969-T01-K

Advertisement

loading