Advertisement
1.MOUNT URINAL
See Fig.#3
Install hangers per roughing-in illustration.
Apply sealant tape to pipe threads and install female collar on
waste pipe. Place washer on female collar.
Install Urinal. Secure urinal to female collar with screws and
washers.
CAUTION:Risk of chipping or breaking urinal.Do not
overtighten screws.
NOTE:Do not caulk top surface of urinal.Caulk may prevent
tank cover from seating properly.
1.安装小便器
请参阅图3
根据安装尺寸示意图安装挂钩。
在管螺纹处缠上密封带，在出水管上安装出水接头。将垫
圈装在出水接头处。
安装小便器，用螺丝和垫圈将小便器紧固在出水接头上。
警告：小便器有破损和崩裂的危险，不要将螺丝上得
过紧。
注意：不要给小便器顶部表面涂胶。涂胶会导致水箱盖无
法盖好。
CONNECT SUPPLY
2.
See Fig.#4
Apply sealant tape to pipe thread and install stop valve
assembly and tighten connection.
NOTE: Stop valve should face left side of tank when
tighten.
Please clean the inside of water supply pipe before connect-
ing to the product.
Plug seal ring into inlet hole of urinal.
Remove the nuts for fixing the bezel and the two clamps.
NOTE: While removing the nuts, avoid dropping bezel,
which may break urinal.
Take off the protection cap of the sensor window. Put the
sensor window into the bezel, fix sensor window with the
clamp and the nuts.
NOTE: Tighten the nuts slightly to prevent damage
sensor window (Do not over tighten the nuts.)
1146969-T01-K
Fig.#3
图3
Clamp
Nut
夹钳片
螺母
Sensor Window
感应窗
Fig.#4
Hangers
挂钩
Collar
排水套环
Apply Sealant Tape
用螺纹密封带
Washer
垫圈
Stop Valve
止水阀
Bezel
嵌板
图4
3
Advertisement
