Gigabyte GA-P55A-UD3P User Manual page 110

For the JMicron JMB362: For the JMicron JMB362:
Step 1: Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps. Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps.
When a screen similar to that below appears (RAID/AHCI hard drive(s) will not be detected at this stage), When a screen similar to that below appears (RAID/AHCI hard drive(s) will not be detected at this stage),
select select Load Driver Load Driver
Step 2: Step 2:
Insert the motherboard driver disk (Method A) or the oppy disk/USB ash drive that contains the SATA RAID/ Insert the motherboard driver disk (Method A) or the oppy disk/USB ash drive that contains the SATA RAID/
AHCI driver AHCI driver (Metho
cal drive, be sure to copy the driver les from the motherboard driver disk to a USB ash drive before cal drive, be sure to copy the driver les from the motherboard driver disk to a USB ash drive before install
ing Windows Vista (go to the ing Windows Vista (go to the
use Method B to load the driver. use Method B to load the driver.
Method A: Method A:
Insert the motherboard driver disk into your system and browse to the Insert the motherboard driver disk into your system and browse to the
\BootDrv\GSA \BootDrv\GSAT
For Windows Vista 64-bit, browse to the For Windows Vista 64-bit, browse to the
Method B: Method B:
Insert the USB ash drive containing the driver les and browse Insert the USB ash drive containing the driver les and browse to
or or \GSA \GSAT T A\64Bit (for Windows Vista 64-bit). A\64Bit
Appendix Appendix
(Figure 9). (Figure 9).
(Method B), then specify d B), then specify the location of the location of th
BootDrv folder and save the whole BootDrv
T A\32Bit A\32Bit
(for Windows Vista 64-bit).
Figure 9 Figure 9
the driver (Figure 1 e driver (Figure
folder and save the whole
64Bit folder. 64Bit folder.
Figure 10 Figure 10
- - 1 110 - 10 -
10). Note: For users u 0). Note: For users using a SA
GSATA GSATA folder to the USB ash drive). Then folder to the USB ash drive). Then
following directory following directory: :
to \GSA \GSAT T A\32Bit A\32Bit (for Windows Vista 32-bit) (for Windows Vista 32-bit)
sing a SAT T A A op opti- ti-
install- -