Table of Contents
Advertisement
B. Installing Windows Vista
B. Installing Windows Vista
The procedure below assumes that only one RAID array exists in your system. Note: You are not required to
The procedure below assumes that only one RAID array exists in your system. Note: You are not required to
load the SATA AHCI driver rst when installing Windows Vista onto the RAID drives attached to the Marvell
load the SATA AHCI driver rst when installing Windows Vista onto the RAID drives attached to the Marvell
9128 controller.
9128 controller.
For the Intel P55:
For the Intel P55:
Step 1:
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps.
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps.
When a screen similar to that below appears (RAID
When a screen similar to that below appears (RAID
Driver
Driver
(Figure 5).
(Figure 5).
Step 2:
Step 2:
Insert the motherboard driver disk (Method A) or
Insert the motherboard driver disk (Method A) or
B), then specify the location of the driver (Figure 5). Note: For users using a SATA optical drive, be sure to
B), then specify the location of the driver (Figure 5). Note: For users using a SATA optical drive, be sure to
copy the driver les from the motherboard driver disk to a USB ash drive before installing Windows Vista (go
copy the driver les from the motherboard driver disk to a USB ash drive before installing Windows Vista (go
to the
to the
BootDrv
BootDrv folder and save the whole
driver.
driver.
Method A:
Method A:
Insert the motherboard driver disk into your system and browse to the
Insert the motherboard driver disk into your system and browse to the
\BootDrv\iRST\32
\BootDrv\iRST\32Bit
For Windows Vista 64-bit, browse to the
For Windows Vista 64-bit, browse to the
Method B:
Method B:
Insert the USB ash drive containing the driver les and browse
Insert the USB ash drive containing the driver les and browse to
iRST\64Bit (for Windows Vista 64-bit).
iRST\64Bit
(for Windows Vista 64-bit).
Appendix
Appendix
folder and save the whole
Bit
64Bit folder.
64Bit
hard drive will not be
hard drive will not be
Figure 5
Figure 5
the oppy disk/USB ash drive that contains the
the oppy disk/USB ash drive that contains the
iRST folder to the USB
iRST
folder to the USB
ash drive). Then use Method B to load the
ash drive). Then use Method B to load the
folder.
to \iRST\32Bit
\iRST\32Bit
Figure 6
Figure 6
- 108 -
- 108 -
detected at this stage),
detected at this stage), select
driver (Method
driver (Method
following
following directory
directory:
:
(for Windows Vista 32-bit)
(for Windows Vista 32-bit) or
select Load
Load
or \
\
Advertisement
Table of Contents
