Sony STR-DA4600ES Operating Instructions Manual page 159

• Be sure to use a connecting cable for the
HDMI jack corresponding to High Speed
HDMI cable when you view images or
listen to sound during a 1080p, Deep
Color, or 3D transmission.
• Images from the component connected to
the HDMI jack may be distorted. In this
case, set "Video Direct" to "ON" in the
HDMI settings menu.
• Images or sound from the component
connected to the HDMI jack may be
interrupted when video signals are
switched. In this case, set "Video Direct"
to "ON" in the HDMI settings menu.
• If the start of the video is not output when
the 3D video is switched, or the colors of
the 3D video are improper, set "Video
Direct" to "ON" in the HDMI settings
menu.
No 3D image appears on the TV.
• Depending on the TV or the video
component, 3D images may not be
displayed. Check the 3D image formats
supported by the system (page 164).
Recording cannot be carried out.
• Check that the components are connected
correctly (page 25).
• Select the source component (page 57).
The GUI does not appear on the TV
screen.
• "GUI MODE" may have been turned off.
Press GUI MODE to turn "GUI MODE"
on.
• Check the TV is connected correctly.
Images appear later than the
associated sound is played when the
HDMI input is selected.
• Depending on the component connected to
the HDMI jack, or the source played back,
images may appear later than the
associated sound. In this case, set "Video
Direct" to "ON" in the HDMI settings
menu.
Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown on page 159. If
you connect the receiver to an outdoor
antenna (aerial), ground it against
lightning. To prevent a gas explosion, do
not connect the ground (earth) wire to a
gas pipe.
Outdoor FM antenna (aerial)
Receiver
Ground (earth)
wire (not supplied)
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• Keep the satellite radio antenna, away
from the speaker cords and the power cord
to avoid picking up noise.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 64).
• Press DISPLAY so that the frequency
appears on the display.
To ground
continued
159 GB