Roll-Out Rack; Positioning Racks And Bakeware - KitchenAid KSGB900ESS Manual

OVEN USE
Odors and smoke are normal when the oven is used the first few
times or when it is heavily soiled.
IMPORTANT: The health of some birds is extremely sensitive to
the fumes given off. Exposure to the fumes may result in death to
certain birds. Always move birds to another closed and well
ventilated room.

Positioning Racks and Bakeware

Use the following illustrations and chart as a guide.
The oven has seven positions for a flat rack, as shown in the
previous illustration and the following table.
Flat Rack Position Type of Food
7 Broiling/searing meats, hamburgers,
steaks
6 Broiled meats, poultry, fish
3 or 4 Most baked goods, casseroles, frozen
foods
2 Roasted meats
1 Large roasts or poultry
IMPORTANT: If your model has a Max Capacity Oven Rack, the
recessed ends must be placed in the rack position above the
desired position of the food. See the following illustration.
A. Ends of rack in position 3
B. Food in position 2
IMPORTANT: These rack positions are for flat racks. If a Max
Capacity Oven Rack is used, the rack position must be adjusted
as shown in the previous figure.
Bakeware
To cook food evenly, hot air must be able to circulate. Allow 2" (5
cm) of space around bakeware and oven walls. Make sure that no
bakeware piece is directly over another.
Multiple Rack Cooking
Two-rack (non-convection): Use rack positions 2 and 5 or 3 and 6.
Two-rack (convection): Use rack positions 2 and 5 or 3 and 6.
Three-rack (convection): Use rack positions 2 and 7 and a Max
Capacity Oven Rack in rack position 5.

Roll-Out Rack

The roll-out rack allows easy access to position and remove food
in the oven. It is not recommended to use the roll-out rack in the
top rack, position 7, or the bottom rack, position 1.
Open Position
A. Rack frame
B. Sliding rack
Closed and Engaged Position
A. Rack frame
B. Sliding rack
To Insert Roll-Out Rack
1. Angle the front of the rack assembly up, and then insert the
rack frame into the "V" cutout in the rack guides of the oven
cavity.
A. "V" cutout
B. Rack guides
2. Keep rack assembly lifted up at an angle, and then push in to
bypass the lower "V" cutout.
3. Lower the front of the rack assembly, and then gently slide
rack assembly into oven, bypassing the "V" cutouts. Push the
rack assembly into the oven until it stops at the ladder in the
back of the oven.
A. "V" cutout
B. Rack guides
D. Ladder hook
E. Ladder
9