KitchenAid KGRS206XSS Installation Manual

Freestanding gas range
Hide thumbs Also See for KGRS206XSS:

Advertisement

Available languages

Available languages

Quick Links

INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE
INSTALLATION AND SERVICE MUST BE
PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL
INSPECTOR'S USE. READ AND SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or death.

FOR YOUR SAFETY:

— Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your
building.
• Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
• If you cannot reach your gas
supplier, call the fire department.
— Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
Provide proper fuel type
Before proceeding: Your range is factory preset to
operate on natural gas. If L.P. conversion is needed,
contact your local L.P. Gas provider for assistance.
The L.P. conversion kit may be located on the lower rear
back panel of the range. If no L.P. kit is provided, contact
your product dealer to obtain the correct L.P. conversion kit.
Important notes to the installer
Read all instructions contained in these installation
instructions before installing range.
Remove all packing material from the oven
compartments before connecting the gas and
electrical supply to the range.
Observe all governing codes and ordinances.
Be sure to leave these instructions with the consumer.
Important notes to the consumer
Keep these instructions with your Use & Care Guide
for future reference.
Be sure your range is installed and grounded properly
by a qualified installer or service technician.
Special instructions for appliances installed in the State of
Massachusetts:
This appliance can only be installed in the State of
Massachusetts by a Massachusetts licensed plumber or
gas fitter. When using a flexible gas connector, it must not
exceed 3 feet (36 inches) in length. A "T" handle type
manual gas valve must be installed in the gas supply line to
this appliance.

IMPORTANT SAFETY INSTRUCTIONS

Installation of this range must conform with local codes or,
in the absence of local codes, with the National Fuel Gas
Code ANSI Z223.1—latest edition when installed in the
United States.
When installed in a manufactured (mobile) home,
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
[formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD (Part 280)] or, when
such standard is not applicable, the Standard for
Manufactured Home Installations, ANSI/NCSBCS A225.1,
or with local codes.
This range has been design certified by CSA International.
As with any appliance using gas and generating heat, there
are certain safety precautions you should follow. You will
find them in the Use & Care Guide, read it carefully.
1
Refer to your serial plate
for applicable agency
certifications
p/n 316903001 (1005)

Advertisement

Table of Contents
loading

Summary of Contents for KitchenAid KGRS206XSS

  • Page 1: For Your Safety

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. Refer to your serial plate for applicable agency IMPORTANT: SAVE FOR LOCAL ELECTRICAL certifications INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. Important notes to the installer •...
  • Page 2 INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE IMPORTANT SAFETY INSTRUCTIONS DO NOT MAKE ANY ATTEMPT TO OPERATE THE ELECTRIC IGNITION OVEN DURING AN • Be sure your range is installed and grounded ELECTRICAL POWER FAILURE. RESET ALL OVEN properly by a qualified installer or service CONTROLS TO "OFF"...
  • Page 3 INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE Tools you will need Tools (Wear safety glasses when using tools): For leveling legs and Anti-Tip Bracket: • Adjustable wrench or channel lock pliers (Fig. a) Fig. e Fig. a • 5/16" Nutdriver or flat head screwdriver (Fig. b) •...
  • Page 4 INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE Installation with cabinets Check location where the range will be installed for proper electric and gas supply, and stability of the floor. The dimensions shown here must 30” be used and are minimal unless 30”...
  • Page 5: Important Safety Warning

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE Install anti-tip bracket IMPORTANT SAFETY WARNING! To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed anti- tip bracket and screws packed with the range. Failure to install the anti-tip bracket will allow the range to tip over if excessive weight is placed on an open door or if a child climbs upon it.
  • Page 6: Provide An Adequate Gas Supply

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE Provide an adequate gas supply. Connect range to gas supply. Please note: Operation at elevations above 2000 ft., Note: To prevent leaks use pipe joint sealant on all male appliance rating shall be reduced at the rate of 4 percent (outside) pipe threads.
  • Page 7: Checking Manifold Gas Pressure

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE c. Tighten the gas supply fitting and/or appliance conduit Checking manifold gas pressure to flare union adaptor on the right side of the pressure Do not use flame to check for gas leaks. regulator (refer to Fig. 10) using NO MORE THAN 15ft./lbs.
  • Page 8: Electric Requirements

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE Read the following electrical Check burner cap placement. connection details before It is very important to be sure that all surface burner caps connecting electricity to range. and burner grates are properly installed and in the correct locations before operating the appliance.
  • Page 9: Check Ignition Of Surface Burners

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE Check ignition of surface burners. Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. a. To check for proper ignition, push in and turn a surface burner knob counterclockwise to the LITE other surface burners for Dual or Twin burner only...
  • Page 10: Make Sure Range Is Level

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE Adjust air shutter - lower oven. Make sure range is level. To determine if the oven burner flame is proper, remove the Level the range by placing a level horizontally on an oven oven bottom panel and lower burner baffle (Refer to Fig. rack.
  • Page 11: Pour Votre Sécurité

    INSTRUCTIONS D’INSTALLATION - CUISINIÈRE À GAZ AUTONOME L’INSTALLATION ET L’ENTRETIEN DOIVENT ÊTRE RÉALISÉS PAR UN INSTALLATEUR QUALIFIÉ. Reportez-vous à la plaque IMPORTANT : CONSERVEZ CES INSTRUCTIONS EN signalétique pour connaître PRÉVISION D’UN USAGE ÉVENTUEL PAR les certifications reconnues. L’INSPECTEUR EN ÉLECTRICITÉ DE VOTRE LOCALITÉ. VEUILLEZ LIRE ET CONSERVER CES INSTRUCTIONS POUR VOUS Y REPORTER ULTÉRIEUREMENT.
  • Page 12: Importantes Mesures De Sécurité

    INSTRUCTIONS D’INSTALLATION - CUISINIÈRE À GAZ AUTONOME IMPORTANTES MESURES DE SÉCURITÉ N’ESSAYEZ PAS DE FAIRE FONCTIONNER LE FOUR À ALLUMAGE ÉLECTRIQUE • Vérifiez que votre cuisinière est installée et mise à la terre DURANT UNE PANNE D’ÉLECTRICITÉ. REMETTEZ TOUTES de façon appropriée par un installateur qualifié ou un LES COMMANDES DU FOUR À...
  • Page 13 INSTRUCTIONS D’INSTALLATION - CUISINIÈRE À GAZ AUTONOME Outils nécessaires Outils (Portez des lunettes de sécurité lorsque vous utilisez les outils) : Pour l’ajustement des pieds de mise à niveau et l’installation du support anti-renversement : • Clé à molette ou pince multiprise ordinaire (fig. a) Fig.
  • Page 14 INSTRUCTIONS D’INSTALLATION - CUISINIÈRE À GAZ AUTONOME Installation avec des armoires Vérifiez ll’alimentation électrique, l’alimentation en gaz et la stabilité du plancher à l’endroit où la cuisinière sera installée. Sauf avis contraire, les dimensions indiquées ici sont des dimensions minimales et doivent 30 po être utilisées.
  • Page 15: Avis De Sécurité Important

    INSTRUCTIONS D’INSTALLATION - CUISINIÈRE À GAZ AUTONOME Installer le support anti-renversement FIXATION DU SUPPORT (SUR LE PLANCHER SEULEMENT) AVIS DE SÉCURITÉ IMPORTANT! Plus de Pied de mise 3,2 cm à niveau (1-1/4 po) Afin de réduire les risques de renversement, la cuisinière doit être fixée au plancher de façon appropriée au moyen du support anti-renversement et des vis fournis avec la cuisinière.
  • Page 16 INSTRUCTIONS D’INSTALLATION - CUISINIÈRE À GAZ AUTONOME Prévoir une alimentation en gaz Raccorder la cuisinière à la conduite adaptée d’alimentation en gaz Remarque : Si l’altitude est supérieure à 610 m (2 000 pi), les Remarque : Pour éviter les fuites, utilisez de la pâte à joint pour caractéristiques nominales de l’appareil doivent être réduites tuyau sur tous les raccords de tuyau de type mâle de 4 % pour chaque tranche de 305 m (1 000 pi) d’altitude au-...
  • Page 17 INSTRUCTIONS D’INSTALLATION - CUISINIÈRE À GAZ AUTONOME Vérifier la pression de gaz au collecteur c. Serrez le raccord d’alimentation en gaz ou la conduite de l’appareil en le branchant à l'adaptateur de raccord-union qui N’utilisez pas de flamme pour détecter se trouve du côté...
  • Page 18 INSTRUCTIONS D’INSTALLATION - CUISINIÈRE À GAZ AUTONOME Lire les consignes suivantes sur le Vérifier le positionnement du branchement électrique chapeau de brûleur avant de brancher la cuisinière. Il est très important de vérifier que tous les chapeaux et toutes les grilles des brûleurs de surface sont correctement installés Avant d’effectuer une réparation, et se trouvent au bon endroit avant d’utiliser l’appareil.
  • Page 19 INSTRUCTIONS D’INSTALLATION - CUISINIÈRE À GAZ AUTONOME Vérifiez l’allumage des brûleurs de surface. Après vous être assuré que la cuisinière et les raccords de la conduite d’alimentation ne présentent aucune fuite, branchez la cuisinière à l’alimentation en électricité et vérifiez le fonctionnement des allumeurs électriques.
  • Page 20 INSTRUCTIONS D’INSTALLATION - CUISINIÈRE À GAZ AUTONOME Régler l’obturateur d’air du brûleur Vérifier que le four est de niveau inférieur du four Mettez le four à niveau en plaçant un niveau à l’horizontale sur une Pour déterminer si la flamme du brûleur du four est correcte, grille du four.

This manual is also suitable for:

Kgrs208xssKgrs308xss

Table of Contents