Daewoo DW-3000 Series Training Manual page 46

Function DWF-100M's,100C's,1098's
Fuse for The washer composed of several electrical parts especially Inlet valve, synchronous Motor, Bubble generator.
Electrical parts These parts use the coil. If the coil is damaged, it give a bad influence to the function of Triac in the PCB.
In order to prevent these parts from breaking, 315mA Fuse is used and assembled in the Harness Ass'y.
So, when the Fuse is opened, first check the resistance of these parts and then if you find some defective parts,
please replace these one, but if you not replace this defective parts you will continously repeat changing Fuse or PCB.
I describe the standard resistance of these parts, please refer to below table.
Other Options The PCB have some optional function by assembling or not of some components such as Diode and Resistance.
Using Drain Pump or not
D910
Load sensing data
D901,902,903
L6(33-2F-2B-27-24-22) 2E-27-23
DWF-900's, 160's, 170's, 174W's
related parts standard resistance
Inlet valve
Synchronous Motor
11000 Ω
Bubble generator
D19
D10,11,12
changing point of resistance
4800 Ω under 2500 Ω
7600 Ω under 5000 Ω
under 7000 Ω
43
DWF-750's, 800's
note
NW-452
J4
D10,11,12
2F-29