Daewoo DW-3000 Series Training Manual page 50

COURSE PROBLEM
Tub I does not
rotate.
Tub I rotates so
slowly.
Only Pulsator
rotates when
spinning.
Spinning
Noise
(DAMAGED) PARTS
Motor
Refer to the TROUBLE SHOOTING FLOW
P.C.B. As
CHART.
V-Belt
Spinning begins before the water is not
Water
completely drained.
There are too much foam between Tub I and
Detergent
Tub O. (Too Much detergent was used.)
Clutch Spring lost tension.
Gear Mechanism
Clutch Tip does not escape enough from the
Clutch Boss.
Nut Pulley Fix is loosed.
Brake Band (Lining) touches the Drum.
Gear Mechanism
Clutch Tip touches the Clutch Boss.
Motor Pulley is cracked.
Motor Pulley
Bolt and Nut of the Motor Pulley are loosed or
cracked.
Suspension As does not operate properly.
Suspension As
1. Housing or Rubber is worn out.
2. Grease was dried up.
Balancer As Salt water was gone out.
Hexagonal Nut Hexagonal Nut (M24) is loosed.
There's some crack on the Base.
Base and Bolts
The Base Fix Bolts were loosed.
CAUSE
Refer to the TROUBLE SHOOTING FLOW
CHART.
Check and repair the draining system.
Use proper quantity of detergent by the
instruction manuals of washing machine and
detergent.
Change the Gear Mechanism As, Clutch Spring
for a new one.
Adjust the overlap of Clutch Tip and Clutch Boss
to 3.5mm~5mm.
Adjust the gap between Control Bolt and Brake
Lever.
Tighten the Nut with a toothed washer.
Change the Gear Mechanism for a new one.
Adjust the overlap of the two parts to
3.5mm~5mm (Deform the Clutch Lever).
Change the Motor Pulley for a new one.
Thighten or change the Bolt and Nut.
Change the worn parts for new ones.
Change the Balancer As for a new one.
Thighten or change the Hexagonal Nut.
Change the Base for a new one.
Thighten the Bolts.
47
SOLUTION