Daewoo DW-3000 Series Training Manual page 29

Problem
Is the Bellow Assembly properly
There is
assembled?
leakage
during
spin
drying
The Brake Band touches
Spin
the Drum Coupling when
Dryer
the Door Spin *O open.
does not
stop with
the Door
Spin *O
open.
Is the electric
connection of the Door
Switch good?
Concerning Drainage
Problem
Are there impurities in
Drainage
the Drain Strainer?
is not
satisfac-
tory
Are there impurities in the
Valve Housing or Inlet Joint?
Is the Drain Selector on the
Water
operation Panel at the DRAIN
keeps
position
draining
during
wash
Check Point
YES
YES
YES
Check Point
NO
NO
NO
Cause
The Waterseal or the oilless
metal in the Bellows Assembly
worn out
NO
Waterproofing not
working due to
defective assembly
The Waterseal or the Oill-
ess Metal in the Bellows
Assembly is worn out
NO
Brake wire
is too short
Brake Band
is worn out
NO
Defective
Door Switch
The contact of the Door
Switch does not open due
to deformity of the lever
of Door Switch
Cause
YES
Impurities are
obstructing drainage
YES
Impurities are
obstructing drainage
Impurities are
blocking the Drain Hose
YES
Mismanupilation
There are impurities
between the impurities
Housing and Valve
Bellows.
26
Solution
Replace Bellows Assembly
Re-assemble Bellows
Assembly
Replace Bellows
Assembly
Replace after loosening
Wire Guide and adjusting
upward
Replace Brake Band
or Brake Fix Assembly
Replace
Door Switch
Replace Door
Switch or reshape
the lever of Door
Switch
Solution
Disassemble Agitator
and take out impurities in
Drain Strainer
Remove impurities
or replace Valve Housing
or Inlet Joint
Remove impurities
Turn Drain Selector
to WASH/RINSE position
Remove impurities
or replace Valve
Housing