Daewoo DW-3000 Series Training Manual page 28

Problem
Is the Condenser properly
The Spin
connected?
Dryer
does not
spin.
The Brake Band is touching
the Drum Coupling
Assembly.
NO
Is the Motor hot?
(In case there is Thermal
Protector)
Is the wiring good?
(Refer to Wiring diagram)
Is the Door Switch Lever properly
placed on the Door Spin *O?
Is the Door Switch terminal
properly connected?
Is the contact of Spin Timer
good?
Is the wash load well balanced?
There are
strange
noise and
severe
vibration
Are clothes or the safety Cover
during
stick out from Spin Basket?
spinning
Is the assembly between the
Drum Coupling Assembly and
Spin Motor or Spin Dryer loose?
Is the Spin Dryer itself well
balanced?
Check Point
YES
NO
NO
YES
YES
YES
YES
YES
YES
NO
YES
Cause
NO
Motor does not start due
to opening the Condenser
circuit.
YES
Brake wire is too long.
Brake Spring is
broken.
YES
Power has been cut off by
the Thermal Protector
NO
Improper wiring
NO
Defective connection
YES
Improper wiring
NO
Defective Spin Timer
Defective Spin Motor
NO
Spin Dryer does not
balanced due to wash
load
NO
Tub is in contact with the
object sticking out
YES
Improper structural
assembly
NO
Spin dryer unbalance
25
Solution
Reconnect
Assemble after loosening
Wire Guide Screw and
adjusting downward
Replace Brake Spring
Power restored when
motor cools
Reconnect wiring
Replace Door Switch or
reshape the Lever
Reconnect the terminal
Replace the Spin Timer
Replace the Spin Motor
Reload the clothes so
they are well balanced
Reload the clothes and
press down the Safety
Cover into Spin Bracket
Tighten the Bolt Drum
Coupling Assembly
Re-assemble Spin Dryer