Table of Contents
Advertisement
Explorer 107 Operation and Maintenance Manual
Section 5 Operations
Do not wear ties, loose fitting clothes or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
This section discusses Emergency,
Set up and features of the Control panels.
5.1 Control Panels
The control panels of the Explorer 107
Laminator are located at the front operating position
of the machine.
To the left of the front operating position is
the Operations Control Panel. This panel enables the
operator to control motor direction, motor speed,
cooling fans, Lower idler tension and Upper idler
tension.
To the right of the front operating position is
the Temperature Control Panel. This panel enables
the operator to control the temperature settings for
the Top Teflon roller, Nip rollers, Bottom Teflon roller
and the Sub heaters.
© GBC Pro - Tech December 1999
WARNING
5.1.1 Operations Control
Panel
INFORMATION
When any command is pressed ( with the
exception of Reverse ) on the Operations
Control Panel, a "beep" will sound. If the
command is held down, the panel will
continuously "beep".
( 1 ) Cooling Fan On
starts the cooling fans. Cooling fans are not motor
circuitry dependent.
COOLING FAN
( 2 ) Cooling Fan Off
stops the cooling fans.
COOLING FAN
Operations
: When pressed,
O N
ON
OFF
: When pressed
O F F
ON
OFF
Page 5 - 1
Advertisement
Table of Contents
