Emergency - GBC Explorer 107 Operation & Maintenance Manual

Explorer 107 Operation and Maintenance Manual

5.2 Emergency

The Explorer 107 Laminator has been designed
with safety as a primary consideration; however, you
must become thoroughly familiar with the controls,
proper operation, proper service procedures, and safety
features of the laminator before using or servicing the
unit.
Use care in lowering the top laminating roller
and know how to react quickly in an emergency. Before
lowering the roller, ensure that nothing is in the nip
area.
Know where the two emergency stop
( E-STOP ) are located before operating the laminator.
E-STOP located above the Temperature
Control Panel on the right side of the front position of
the laminator. Refer to Figure 5.2.1
Figure 5.2.1 Front E-STOP
© GBC Pro - Tech December 1999
E - S T O P
E-STOP located above the serial plate on the
right side from the rear position of the laminator.
Refer to Figure 5.2.2
Figure 5.2.2 Rear E-STOP
!
R O L L L A M I N A O R
Model Exp or r 1
I put ol age 22 / 6 Hz
nput cur ent 2 A
ower cun up ion 5 8 W
empera ure r nge Up t 16 C
Cur ent ra ing of c rcu t brea er 3 A
Max amina ing wid h 1 5 mm
Ser al No ###### ######
Made n Ko ea / abr que En Coree
In addition, the NipRollers, Teflon Rollers and
Sub Heaters of the Explorer 107 can reach
o
temperatures over 200
At these temperatures there is a danger of
severe burns if the rollers are touched
during set up, operation or servicing.
Operations
E - S T O P
o
F ( 93 C ).
WARNING
Page 5 - 9