Vertical Storage Function - Snapper ESXD19SPWM82 User Manual

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
REPLACING THE CUTTING BLADE
See figure 11-12.
NOTE: Only use authorised replacement
blades. Replace worn or damaged blades
and bolts in sets to preserve balance.
■ Stop the motor and remove the switch
key. Allow blade to come to a complete
stop.
■ Remove the battery pack.
■ Turn the mower on its side.
■ Wedge a block of wood between the
blade and mower deck to prevent the
blade from turning.
■ Loosen the blade bolt by turning it
counterclockwise
bottom of mower) using a 27 mm wrench
or socket (not provided).
■ Remove the blade bolt and blade.
■ Place the new blade on the shaft. Ensure
blade is properly seated with shaft going
through center blade hole and the two
blade posts on the fan inserted into their
respective holes on the blade. Make
sure it is installed with the curved ends
pointing up toward the mower deck and
not down toward the ground. When
seated properly, the blade should be flat
against the fan.Thread the blade bolt on
the shaft and finger tighten.
■ Torque the blade bolt down clockwise
using a torque wrench (not provided)
to ensure the bolt is properly tightened.
The recommended torque for the blade
bolt is 62.5~71.5 kgfcm (350-400 in.-lb.).
English (original instructions)
(as viewed from

VERTICAL STORAGE FUNCTION

See figure 13.
■ Remove the battery from the mower.
■ Remove the grass catcher bag.
■ Rotate the handle knobs to the unlocked
position.
■ Lower the handle assembly and rotate
the handle knobs to the locked position.
■ Lift the mower by the front end to the
vertical position.
Always remove the battery from the
mower before placing the unit in the
vertical storage position.
STORAGE SWITCH
When the handle is rotated into the fully
locked storage position, the mower is
equipped with a storage switch that will
disable the mower from running in the
storage position. The storage switch does
not replace the need to remove the switch
key and battery to prevent accidental
startup or unauthorized use.
11
WARNING