Operation; To Remove Battery Pack; Starting/Stopping The Mower - Snapper ESXD19SPWM82 User Manual

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
the cutting position to the height best suited
for your lawn. The average lawn should be
between 38 mm and 51 mm during cool
months and between 51 mm and 70 mm
during hot months.
To adjust the blade height
■ To raise the blade height, grasp the
height adjustment lever and move it
toward the back of the mower.
■ To lower the blade height, grasp the
height adjustment lever and move it
toward the front of the mower.

OPERATION

WARNING
Do not allow familiarity with products to
make you careless. Remember that a
careless fraction of a second is sufficient
to infl ict serious injury.
WARNING
Always wear eye protection. Failure to do
so could result in objects being thrown
into your eyes resulting in possible
serious injury.
WARNING
Do not use
accessories not recommended by the
manufacturer of this product. The use
of attachments or accessories not
recommended can result in serious
personal injury.
WARNING
Always inspect mower for missing or
damaged parts and blade for damage,
uneven, or excessive wear prior to use.
Using a product with damaged or missing
parts could result in serious personal
injury.
■ Do not tilt the lawn mower when starting
the engine or switching on the motor,
unless the lawn mower has to be tilted
for starting. In this case, do not tilt it
English (original instructions)
any attachments
more than absolutely necessary and
lift only the part which is away from the
operator.
■ Do not start the engine when standing in
front of the discharge chute.
■ Do not put hands or feet near or under
rotating parts. Always keep clear of the
discharge opening.
For complete charging instructions, refer to
the operator's manual for the battery packs
and chargers listed in the specifications
section.
TO INSTALL BATTERY PACK
See figure 8.
■ Lift and hold up the battery door.
■ Align the battery with the mower's
battery port.
■ Make sure the battery release button
snaps in place and that battery is fully
seated and secure in the mower before
beginning operation.
■ Close the door.

TO REMOVE BATTERY PACK

See figure 8.
■ Release the power lever to stop the
product.
■ Remove the switch key.
■ Open the battery door.
or
■ Press the battery release button on the
mower. This will cause the battery to
raise out of the tool slightly.
■ Remove battery pack from the product.

STARTING/STOPPING THE MOWER

See figure 9.
■ Insert the switch key.
■ If the machine is not going to be used
immediately, do not insert the switch
key.
■ Press and hold the start button.
■ Pull the power lever upward to the
handle to start the mower and release
the start button.
■ To stop the mower, release the power
lever.
8