Step 3: Motor Assembly - Hunter 24' Titan Installation Manual

INSTALLATION
A B
Insert retention link Align the connector from the motor with the
into fork and align downrod connector.
holes.
Twist the collar on the connector to complete the
Insert clevis pin connection. Do not force. Connectors should slide
into retention rod together as they twist.
and secure with
Be sure to twist until the connection locks.
provided clip.
Zip tie the motor cable to the safety cable to reduce
the opportunity to pinch the cable
A
B
C

STEP 3: MOTOR ASSEMBLY

CRUSH HAZARD. To prevent serious injury or death, ALWAYS attach the retention
cable to the fan motor and secure to the building structure on EVERY fan.
C
Lift motor up to downrod while
pushing cables into downrod.
Feed the press studs through
downrod flange.
Secure with nylon lock nuts. (Pull
excess wire and cable through
top of downrod.)
NOTE
Leave
approximatlely 3"
of slack in the wire
and the cable at the
top of the downrod
opening.
NOTE
Be sure not to pinch the
motor cable when raising the
downrod into place.
19mm
Deep socket
or wrench
15