Procedure For Simple Connection - Sony MVS-6000 User Manual

Procedure for Simple Connection

To connect the MKS-8080/8082 AUX Bus Remote Panel to a CCP-9000
Center Control Panel using an S-Bus data link requires a BKPF-R70A Routing
Switcher Controller Board or similar primary station and various settings for
connection.
However, using a simple connection, the need for an S-Bus data link primary
station is avoided, and direct connection to the MKS-8080/8082 is possible.
A simple connection is possible if the following conditions are met:
• There are no devices other than the CCP-9000 and MKS-8080/8082
• There are no more than 16 MKS-8080/8082 units connected on the S-Bus
To carry out simple connection of the MKS-8080/8082 AUX Bus Remote
Panel, use the following procedure.
For settings on the MKS-8080/8082, see the section "Making the Setting With
Buttons (Setup Function)" in the Operation Manual for the MKS-8080/8082.
1
2
3
4
5
222
Procedure for Simple Connection
connected on the S-Bus data link.
data link.
Carry out initialization of the MKS-8080/8082 settings.
This can be done on the MKS-8080/8082 separately.
Set the MKS-8080/8082 station number in the range 2 to 17.
This can be done on the MKS-8080/8082 separately.
Set the S-Bus data link primary station to the CCP-9000/9000A Center
Control Panel by setting the STATION ID switches S903 on the front of
the board in the SCU SLOT 1 to 001 (switch 1 only to the OPEN position).
System control unit
MKS-9011/9012
MKS-9011A/9012A
In the Engineering Setup >System >Initialize menu, select PNL, and carry
out a reset.
This carries out a restart, and when the restart is completed connection to
the MKS-8080/8082 is possible.
In the Engineering Setup >Router/Tally > Router menu, set the position of
the MVS-6000 system in S-Bus space.
Board
CA-52
FP-141
STATION ID switches
S903
S108