M20013 REL-0000 (2103)
Stopping the Relief Valve Test
At any time during the test you may
1.
Press the
digits continue to blink to indicate the hold status.
2. Press the
message appears. The test restarts.
OFF
3. Press the ✓
you use these keys.
Display information from two sensors
When you first turn on the Smart Manometer, you see the
screen and only the internal sensor information displays.
▪
Press the
Press the
▪
and external sensors displays. The internal sensor displays in
large characters while external sensor information displays in
small characters.
Press the
▪
(internal measurement units).
Note: Differential displays are not available if either pressure
▪
sensor is a differential sensor or tethered sensor is a
temperature sensor.
Press the
▪
units (external measurement units).
Press the
▪
units (internal measurement units).
▪
Press the
Press the
▪
User Manual HHP460 Smart Manometer with Altimeter & Air Speed Test
Stop
key and the
HOLD.ON
Zero
key to turn off the hold status and the
to exit the test. The results are lost when
OR X
Up arrow
and external sensor information displays.
Up arrow
again and information for both the internal
Up arrow
and Diff P1-P2 scrolls with P1 Units
Left or Right arrow
and Diff P2-P1 scrolls with P2
Left or Right arrow
and Diff P1-P2 scrolls with P1
Down arrow
to reverse the sequence.
Home
key at any point to return to the
message appears. The
HOLD.
Home
Home
screen.
34 of 72