Functional Description; Specifications - Milwaukee M12 Series Operator's Manual

FUNCTIONAL DESCRIPTION

1. Laser apertures
2. Laser mode indicator
3. On/Off dial
4. Pivot Bracket
1
1
1
1
7
6
5
10
9

SPECIFICATIONS

Cat. No. ..................................................... 3622-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
Laser............................................................Class 2
Lines Max Power ................................. P
Points Max Power................................ P
Pulse Frequency..........................................10 KHz
Pulse Duration Normal Mode ................. T
Pulse Duration Power Save.................... T
Wavelength.......................................... 510-530 nm
Lines Beam Divergence ................................. 1 rad
Points Beam Divergence .......................... 0.5 mrad
Storage Temp .................................... -4°F to 120°F
Working Range .................................................125'
Range with Detector .........................................165'
Accuracy ...............................................±1/8" @ 33'
Settle Time ......................................... < 3 Seconds
Tripod Mount ..................................1/4"-20, 5/8"-11
Ingress Protection............................................ IP54
Drop Rating .......................................................1 m
Leveling ............Auto ±°4 side to side, front to back
Recommended Ambient
Operating Temperature .................. 14°F to 104°F
5. Micro adjust
6. Fuel gauge
7. Mode button
2
3
4
8. Threaded inserts
9. Magnets
10. Nail/Screw hole
8
≤ 7 mW
AVG
≤ 1 mW
AVG
≤ 80 µs
p
≤ 50 µs
p
SYMBOLOGY
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Power Save
Use power save mode to extend the battery run
time. Power save mode is indicated by dimmed laser
beams and the Mode indicator pulsing. Visual range
is decreased in power save mode. To turn power save
mode ON or OFF, press and hold Mode button for 3
seconds. The tool will automatically switch to power
save mode if less than 7% of battery charge remains.
Fuel Gauge
To determine the amount of charge left in the battery,
turn the tool ON.
LEDs Description
4 LEDs 66-100% Battery charge
3 LEDs 45-65% Battery charge
2 LEDs 18-44% Battery charge
1 LED 8-17% Battery charge
1 LED flashing 0-7% Battery charge
Power Save Mode enabled.*
1 LED flashes End of charge.
4 times & tool Charge the battery pack.
will not run
4 LEDs flash System error. Tool shuts off.
alternately Contact a MILWAUKEE service
facility
*When automatically switched to power save mode
due to low battery, the tool cannot be switched back
to normal mode until the battery is charged/replaced.
3
Volts
Direct Current
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
Magnets
Read operator's manual