2.
Remove the three Phillips M2.0 × 5.0 screws (1) that secure the system board USB bracket to the
computer.
3.
Remove the bracket (2).
4.
Remove the four Phillips M2.0 × 4.0 screws (3) that secure the system board to the computer.
5.
Lift the right side of the system board (4), and then pull the board up and to the right to remove it (5).
Reverse this procedure to install the system board.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Before removing the display panel, follow these steps:
Component replacement procedures
35