b.
Lift the panel up (2), and then rotate it over and place it next to the display rear cover.
The display panel is available as spare part number M49289-001.
c.
Release the cable from the left hinge cover (1). The rubber cable holder (2) releases from the inside
of the hinge cover when you remove the cable. Be sure to replace this rubber piece when
reassembling the display assembly.
d.
Remove the tape from the connector on the back of the display panel (1).
e.
Disconnect the cable from the panel (2).
f.
Disconnect the cable from the sensor board on the bottom of the panel (3).
g.
Disconnect the cable from the end of the touch control board on the bottom of the panel (4).
h.
Remove the cable from the clips along the bottom of the display panel (5), and then remove the
cable. The display cable is available as spare part number M47235-001.
Component replacement procedures
37