Figure 24. Connecting the power cords
3. If applicable, close the rack door at the rear of the system.
4. Store the drive or drives that you permanently removed in a safe place.
5. Start the system. For instructions, see Starting a system (www.ibm.com/support/knowledgecenter/
POWER9/p9haj/crustartsys.htm).
6. Turn off the identify LED. For instructions, see Deactivating an identify LED (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/p9haj_turn_off_identify_led.htm).
Disk drives or solid-state drives for the 9040-MR9 system 39