Preparing The System For Operation - IBM Power System 9040-MR9 Manual

Figure 7. Installing a drive in a system
Important: Ensure that the drive is fully seated and is all the way into the system.
f) Press Enter on the console to indicate that you installed the drive.
9. If you want to install more drives, repeat the steps in this procedure. Otherwise, continue with the next
topic.
Preparing the 9040-MR9 system for operation after installing a disk drive or solid-state
drive
To prepare the system for operation after you install a disk drive or solid-state drive (SSD), complete the
steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Choose from the following options:
• If your system has the power turned off, continue with step "3" on page 12.
• If your system has the power turned on, continue with step "6" on page 13.
3. Using your labels, reconnect the power cords (A) to the system unit.
12 Power Systems: Disk drives or solid-state drives