Preparing The System For Operation - IBM Power System 9040-MR9 Manual

Figure 17. Installing a drive in a system
Important: Ensure that the drive is fully seated and is all the way into the system.
h) Press Enter on the Complete Device Concurrent Add display to indicate that the drive is installed.
The service indicator stops flashing and turns off for that drive slot.
8. If you want to replace another drive, repeat this procedure. Otherwise, continue with the next topic.
Preparing the 9040-MR9 system for operation after removing and replacing a disk drive
or solid-state drive
To prepare the system for operation after you replace a disk drive or solid-state drive (SSD), complete the
steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Choose from the following options:
• If you completed the procedure with the system power turned off, continue with step "3" on page
28.
• If you completed the procedure with the system power turned on, continue with step "7" on page
28.
Disk drives or solid-state drives for the 9040-MR9 system 27