9. Repeat Steps 7 and 8 to install the retaining plate and hardware to the other side of the pivot shaft.
Cable Routing
1. Route cable through pulley brackets on the base frame assembly and up through the pulley bracket on the input
arm assembly with pulleys.
2. Install screw securing the rod end bearing to the input arm assembly using an 8mm Allen wrench.
Item
1
2
3
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Page 25 of 38
Description
Rod End Bearing
Screw, M10 x 1.5, 35mm
Input Arm Assembly
Qty.
1
1
1