6. Place work arm assembly into the grooves on the base frame assembly.
NOTE: Position the pivot shaft so that the flat side is facing down before lowering the work arm assembly into the
base frame assembly.
7. Install screws, washers, and locknuts securing the retaining plate to the base frame assembly using an 8mm Allen
wrench and a 17mm wrench.
8. Install screw and fender washer securing the retaining plate to the base frame assembly using an 8mm Allen
wrench.
Item
1
2
Item
1
2
3
4
5
6
7
Tighten hardware to 14-16 ft-lb (19-21.7 Nm).
Page 24 of 38
Description
Work Arm Assembly
Base Frame Assembly
Description
Retaining Plate
Base Frame Assembly
Screw, M10 x 1.5, 25mm
Screw, M10 x 1.5, 30mm
Washer, Flat 3/8"
Washer, Fender 3/8"
Nut, M10 x 1.5, Hex Nylock
Qty.
1
1
Qty.
1
1
1
4
4
1
4