8. Starting at the top, press the shroud retainers into the rear shroud securing it to the tower frame.
9. NOTE: OPTIONAL: If your product does not include front shrouds, skip this step.
Install screws and washers securing the bottom cap to the bottom of the tower frame using an 8mm Allen wrench.
10. Install hole plugs into holes in the bottom of the tower frame. Discard hole plugs if your product includes front
shrouds.
Item
1
2
Item
1
2
3
Tighten hardware to 8-10 ft-lb (10.8-13.5 Nm).
Item
1
Page 17 of 36
Description
Shroud Retainer
Rear Shroud
Description
Bottom Cap
Screw, M10 x 1.5, 20mm
Washer, Flat 3/8"
Description
Hole Plug, 8.7 mm
Qty.
6
1
Qty.
1
2
2
Qty.
2