Operation
Use the Wash Feature
The wash feature uses water (without abrasive) to rinse
areas that have been blasted with abrasive. It is also a
convenient feature for flushing abrasive from the blast
hose.
There will always be some residual abrasive in the
blast hose. Never use the wash feature on any
surface other than where you have blasted, or intend
to blast. It will affect/dull the surface.
Do not use the wash feature on wood that has been
blasted. It could damage the wood and cause the
grain to rise. Wait for the wood to dry and then use a
broom, brush, or vacuum to remove any residual
abrasive.
1. Close the abrasive ball valve (M).
M
24
NOTICE
NOTICE
2. Turn the selector valve to WASH.
3. Blast 1-2 minutes until the abrasive is cleared from
the hose.
4. The equipment is now ready to wash any previously
blasted surfaces.
3A7467D