Fill Pot with Abrasive Media
1. Verify that the pot seal plunger (F) is in the DOWN
position. If the plunger is in the up position, perform
the Pressure Relief Procedure procedure, page
19.
2. Verify that Installation, page 12, is complete.
3. Close the rinse ball valve (X) and the abrasive ball
valve (M).
4. Turn the selector valve (W) to OFF.
W
F
. 1: Turn the Selector Valve Off
IG
5. Open the pot dump valve (J).
X
F
. 2: Open the Pot Dump Valve
IG
6. Open the quick drain valve (ZL).
3A7467D
7. Prepare the pot to accept media:
-
To fill an empty pot: Fill approximately half the
pot (E) with water, until the water drains from
the quick drain valve (ZL). Shut the quick drain
valve.
-
To refill the pot during operation: open the
quick drain valve (ZL) to drain the water until the
pot is approximately half full. Shut the quick
drain valve.
F
. 3: Fill the Pot
IG
8. Add abrasive media to the pot.
NOTE: The media level should be a few inches below
the pot seal plunger (F). Do not overfill the pot with
abrasive material, or the pot seal plunger will not be able
to seal.
NOTE: As long as the abrasive media is below the
plunger, the water level can rise above the pot seal
plunger (F) without affecting performance.
J
ZL
F
. 4: Add Abrasive Media
IG
J
ZL
ti37626a
F
Setup
E
ti37627a
17