Product Overview; Specifications; Attachments/Accessories; Operation - Toro Reelmaster 5010 Series Operator's Manual

Product Overview

Specifications

Cutting Unit
03638
03639
03641
03643

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
Weight
54 kg (118 lb)
54 kg (118 lb)
55 kg (121 lb)
55 kg (121 lb)
6

Operation

Refer to your traction unit Operator's Manual for
detailed operation instructions. Before using the
cutting unit each day, adjust the bedknife; refer to
Adjusting the Bedknife to the Reel (page
quality of cut by cutting a test swath before using the
cutting unit to ensure that the finished cut is correct.
Note:
Determine the left and right sides of the
machine from the normal operating position.

Adjusting the Cutting Unit

Adjusting the Rear Shield
Under most conditions, you can attain the best
clipping dispersion when the rear shield is closed
(front discharge). When conditions are heavy or wet,
you may open the rear shield.
To open the rear shield
securing the shield to the left side plate, rotate the
shield to the open position, and tighten the bolt.
1. Bolt
Checking the Cutting Unit
The dual knob bedknife-to-reel adjustment system
incorporated in this cutting unit simplifies the
adjustment procedure needed to deliver optimum
mowing performance. The precise adjustment
possible with the dual knob/bedbar design gives
the necessary control to provide a continual
self-sharpening action-thus maintaining sharp cutting
edges, ensuring good quality of cut, and greatly
reducing the need for routine backlapping.
7). Test the
(Figure 6), loosen the bolt
Figure 6
2. Rear shield
g027161