Service Mode - Fostex VR800Z Service Manual

4. SERVICE MODE

There are various optional modes available in the VR800 Service Mode. Please utilize them when servicing the unit.
4-1. Putting VR800 into Service Mode
The way of putting the VR800 into Service Mode is as follow.
1. Connect a SCSI device, insert the diskette formatted by the VR800 and turn the power of SCSI device on.
2. After confirming that the access LED on the SCSI device is lit and then goes out, turn on the power of VR800.
3. While holding down the [STOP] button and [SHIFT] key, press the [SETUP] key.
As shown below, by rotating the jog dial C.W. or C.C.W., various optional modes will be displayed in addition
to the general SETUP menus. In order to select a certain optional mode, press the [EXECUTE/YES] key while
its menu is displayed.
Sign.Set? TempoSet? TitleEdit?
N/A
N/A
N/A
C.W.
N/A
C.W.
N/A
BkFormat?
Format?
Save_PGM? Load_PGM? NOsEvent?
C.W.
Version?
C.W.
N/A
N/A
C.W.
Test_1? Freeblock? FlashROM? Init.Disk?
C.W.
VR800 LCD Display Section
Del_PGM? Click_ ? Preroll?
DA_Test? Disp.Test?
SelfCheck?
C.W.
OfsetDisp?
DeviceID? Resolu? Digi.out?
VR800 / VR800Z
SyncOut?
FrameRate?
MtcOffset?
OfsetMode?
C.W.
SlaveMode?
SlaveType?
RecProtect?
Format?
Digi.In?
: SETUP Mode menu
: Service Mode menu
N/A : Not Available
9