Fostex VR800Z Service Manual page 16

VR800 / VR800Z
4-6. Offset Display
4-7. Initializing Disk
16
: blinking
This mode determines if the offset value against a master machine
should be displayed when the VR800 is working as a slave
machine. If you would like to turn "ON" the offset display, press
the [EXECUTE/YES] key while "?" is blinking. (The default
setting is "off".) Then, turn the jog dial C.W. to change the setting
to "ON" and press the [EXECUTE/YES] key.
In order to check the offset value, select the "MTC" time base
and the "REMAINING TIME" display. The display below is an
example of offset display.
CAUTION:
There might be a case that the percentage value does not indicate
"0.0%" exactly. This is caused by the difference of internal clocks
between master and slave machines, which are running
independently.
: blinking This mode initializes an external SCSI device connected to the
SCSI port or an internally installed drive. The disk drive currently
connected can be initialized.
?
CAUTION:
1. If both the external SCSI drive and the internal drive are
connected at the same time, the current drive will be initialized.
2. Up to 2 x SCSI drives can be connected to the VR800 at a
time. One is for recording / reproducing (SCSI ID: 0 ~ 5) and
the other for exclusive backing up (SCSI ID: 6). Initializing
is possible on the SCSI drive (ID: 0 ~ 5) used for recording /
reproducing only.
After pressing the [EXECUTE/YES] key, "SURE?" will start
: blinking
blinking in the FL display. In this condition, pressing the
[EXECUTE/YES] key one more time would initialize the
recognized disk drive. This mode puts the disk back to the
?
condition originally formatted.