Pre-Positions And Tours; Pre-Position Settings - Bosch AUTODOME IP starlight 7000i Series User Manual

AUTODOME IP starlight 7000i
Notice!
The compass feature is not compatible with Bosch's Intelligent Tracking feature. If Intelligent
Tracking is activated, the camera automatically disables the display of the compass heading.
Once Intelligent Tracking is deactivated, the camera returns the compass heading to the
display.
You must first calibrate the camera to North before the camera displays accurate compass
headings. The camera uses this calibration, usually set to magnetic North, as the zero degree
pan position and as the North compass heading. The camera then displays the compass
heading based on the number of degrees from the North calibration point.
To set the North calibration point:
1.
2.
3.
North point
–
–
5.10

Pre-positions and Tours

The camera can store up to 256 preset scenes. You can define the individual scenes that
comprise a Pre-position Tour.
You define individual pre-position scenes, then use these scenes to define the Pre-position
Tour. The tour starts from the lowest scene number in the tour and progresses sequentially to
the highest scene number in the tour. The tour displays each scene for a specified dwell time
before advancing to the next scene.
By default, all scenes are part of the Pre-position Tour unless removed.
To define a Pre-position Tour:
1.
2.
3.
4.
5.
5.11

Pre-position settings

Name
Change the name of the pre-position if needed. Click Set to save the new name.
Pre-position
Select the number of the pre-position for which to save specific settings.
Automatic exposure
Select the automatic exposure mode. Options are Full-screen or Defined
Bosch Security Systems
Determine the North compass heading, then move the camera to that position.
Select the radio button On for the parameter Compass.
Click the button next to North point to set the calibration point.
Click the Set button to overwrite the existing North point. A dialog box appears with the
message, "Overwrite North point?" To confirm, click OK. To cancel, click Cancel.
Click the Clear button to reset the North point to factory defaults. A dialog box appears
with the message, "Reset North point to factory defaults?" To confirm, click OK. To
cancel, click Cancel.
Create the individual pre-positions.
By default, all scenes in the list Pre-positions are in the Pre-position Tour.
To remove a pre-position from the tour, select the pre-position in the list and uncheck the
box Include in standard tour (marked with *).
Select a dwell time from the drop-down list Standard pre-position tour.
To start the Pre-position Tour:
Return to the Live page.
Click AUX Control.
Type 8 in the input box and click AUX on.
To stop the tour, type 8 and click AUX off.
User Manual
Camera | en 37
2019-11-21 | v0.5 |