Table of Contents
Advertisement
Completing the configuration
Completing the configuration
Configuring the DMZ interface
Configuring the WAN2 interface
Setting the date and time
Changing antivirus protection
50
Use the information in this section to complete the initial configuration of the FortiGate
unit.
If you are planning to configure a DMZ network, you might want to change the IP
address of the DMZ interface. Use the following procedure to configure the DMZ
interface using the web-based manager.
1
Log into the web-based manager.
2
Go to System > Network > Interface.
3
For the dmz interface, select Modify
4
Change the IP address and Netmask as required.
5
Select Apply.
If you are planning to configure a second internet connection using the WAN2
interface, you might want to change the IP address of the WAN2 interface. Use the
following procedure to configure the WAN2 interface using the web-based manager.
1
Log into the web-based manager.
2
Go to System > Network > Interface.
3
For the wan2 interface, select Modify
4
Change the IP address and Netmask as required.
5
Select Apply.
For effective scheduling and logging, the FortiGate system date and time should be
accurate. You can either manually set the system date and time or you can configure
the FortiGate unit to automatically keep its time correct by synchronizing with a
Network Time Protocol (NTP) server.
To set the FortiGate system date and time, see
page
127.
By default, the FortiGate unit scans all web and email content for viruses. You can use
the following procedure to change the antivirus configuration. To change the antivirus
configuration:
1
Go to Firewall > Policy > Internal->WAN1.
2
Select Edit
to edit this policy.
3
For Anti-Virus & Web Filter you can select a different Content Profile.
See
"Factory default content profiles" on page 35
content profiles.
NAT/Route mode installation
.
.
"Setting system date and time" on
for descriptions of the default
Fortinet Inc.
Advertisement
Table of Contents
