Table of Contents
Advertisement
RIP configuration
Adding a RIP filter list
FortiGate-60R Installation and Configuration Guide
If you want to filter multiple routes, use a RIP filter list. See
page
125.
1
Go to System > RIP > Filter.
2
Select New to add a RIP filter.
3
Configure the RIP filter.
Filter Name
Enter a name for the RIP filter. Each RIP filter and RIP filter list must have
unique name. The name can be 15 characters long and can contain upper
and lower case letters, numbers, and special characters. The name cannot
contain spaces.
Blank Filter
Used for Filter lists. See
IP
Add the IP address of the route.
Mask
Add the netmask of the route.
Action
Select Allow so that the filter permits this route to be communicated. Select
Deny to stop this route from being communicated.
Interface
Select the interface on which to apply this RIP filter.
4
Select OK to save the RIP filter.
Add a RIP filter list to filter multiple routes. A RIP filter list consists of a RIP filter name
and a series of route prefixes. You can add a total of four RIP filters or RIP Filter lists.
When a RIP filter list is added to the neighbors or routes filter, all of the routes in the
RIP filter list are filtered.
1
Go to System > RIP > Filter.
2
Select New to add a RIP filter.
3
Configure the RIP filter list name.
Filter Name
Enter a name for the RIP filter list. Each RIP filter and RIP filter list must
have unique name. The name can be 15 characters long and can contain
upper and lower case letters, numbers, and special characters. The name
cannot contain spaces.
Blank Filter
Optionally select blank filter to start the RIP filter list with a blank x. After
adding the blank filter you can add routes to the RIP filter list.
4
Select OK to save the RIP filter list.
5
For the RIP filter list name, select
6
Configure the route prefix.
IP
Add the IP address of the route.
Mask
Add the netmask of the route.
Action
Select Allow so that the filter permits this route to be communicated. Select
Deny to stop this route from being communicated.
Interface
Select the interface on which to apply this RIP filter.
7
Select OK to add the route prefix to the filter list.
8
Repeat steps
5
to
"Adding a RIP filter list" on page
Add Prefix to add a route prefix to the filter list.
7
to add route prefixes to the filter list.
Adding RIP filters
"Adding a RIP filter list" on
125.
125
Advertisement
Table of Contents
