Table of Contents
Advertisement
Using the setup wizard
Using the setup wizard
Starting the setup wizard
Reconnecting to the web-based manager
Using the command line interface
Configuring the FortiGate unit to operate in NAT/Route mode
46
From the web-based manager, you can use the setup wizard to create the initial
configuration of your FortiGate unit. To connect to the web-based manager, see
"Connecting to the web-based manager" on page
1
Select Easy Setup Wizard (the middle button in the upper-right corner of the
web-based manager).
2
Use the information that you gathered in
Select the Next button to step through the wizard pages.
3
Confirm your configuration settings and then select Finish and Close.
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For each server located on your
internal network the FortiGate unit adds a WAN1->Internal policy. For each server located on
your DMZ network, the FortiGate unit adds a WAN1->DMZ policy.
If you used the setup wizard to change the IP address of the internal interface, you
must reconnect to the web-based manager using a new IP address. Browse to https://
followed by the new IP address of the internal interface. Otherwise, you can reconnect
to the web-based manager by browsing to https://192.168.1.99.
You have now completed the initial configuration of your FortiGate unit, and you can
proceed to
"Connecting the FortiGate unit to your networks" on page
As an alternative to using the setup wizard, you can configure the FortiGate unit using
the command line interface (CLI). To connect to the CLI, see
command line interface (CLI)" on page
Use the information that you gathered in
following procedures.
Configuring NAT/Route mode IP addresses
1
Log into the CLI if you are not already logged in.
2
Set the IP address and netmask of the internal interface to the internal IP address and
netmask that you recorded in
set system interface internal mode static ip <IP address>
<netmask>
Example
set system interface internal mode static ip 192.168.1.1
255.255.255.0
30.
Table 12 on page 44
31.
Table 12 on page 44
Table 12 on page
44. Enter:
NAT/Route mode installation
to fill in the wizard fields.
48.
"Connecting to the
to complete the
Fortinet Inc.
Advertisement
Table of Contents
