Thermostat Connection - Vermont Castings Stardance SDDVT Series Installation & Operating Manual

Left Log
Figure 3.28 - Front Logs
Rear Log
LG494
left/right logs
6/07
Left Log
Figure 3.29 - Completed Installation
LG495
E. Thermostat Connection
SDDVT logs complete
6/07
Use only a thermostat rated for 500 - 750 millivolts.
Check the table below for the appropriate gauge thermostat
wire to use for the length of lead required in your installation.
Thermostat
Wire / Gauge
18
16
14
1. Install the wall thermostat in the desired location and run
the wires to the stove location. Terminate these leads
with 1/4" female connectors.
2. Connect the thermostat or wall switch wires to the valve,
Figure 3.30.
2424
Right Log
Top Log
Right Log
Ember Bed
(optional):
Maximum Run
20 Feet
20 - 40 Feet
up to 60 Feet
Vermont Castings • Stardance SDDVT Installation Manual_R23 • 11/21
SIT VALVE
Thermopile
Millivolt Thermostat
Figure 3.30 - Install wiring to Thermostat before connecting to valve.
FP1622
!
SIT valve w/switch
Electrical connections should only be performed by a
qualified, licensed electrician. Main power must be off
when connecting to main electrical power supply or
performing service. All wiring shall be in compliance
with all local, city and state codes. The appliance, when
installed, must be electrically grounded in accordance
with local codes or in the absence of local codes, with the
National Electrical Code ANSI/NFPA 70 (latest edition) and
Canadian Electrical Code, CSA C22.1.
!
Label all wires before disconnecting when servicing
controls. Wiring errors can cause improper and dangerous
operation.
!
Do not connect wall switch to 110 V circuit.
!
Electrical connections should only be performed by a
qualified, licensed electrician. Main power supply must
be turned off before connecting fans to the main electrical
power supply or performing service.
Valve
WARNING
CAUTION
WARNING
CAUTION
3-90-30007467