Resetting A Fortigate-5001A Board - Fortinet FortiGate FortiGate-5001A Security System Manual

Hardware installation
5
6
7
8
9

Resetting a FortiGate-5001A board

FortiGate-5001A Security System Guide
01-30000-0438-200800801
Open the left and right handles to their fully open positions.
Pivoting the handles turns off the microswitch, turns off all LEDs, and ejects the
board from the chassis slot. You need to use moderate pressure to eject the
board.
Alignment Pin
Handle
Open
Lock
Pull the board about half way out.
Turn both handles to their fully-closed positions.
When the right handle is fully-closed it locks into place.
Alignment Pin
Close
Handle
Carefully slide the board completely out of the slot.
Re-attach the protective metal frame if you are going ship the FortiGate-5001A
board or store it outside of a chassis.
You can use the handle on the right side of the FortiGate-5001A board to cycle
the power and reset the board without ejecting the board from its slot. The right
handle is the handle closest to the front panel LEDs. If the FortiGate-5001A board
is installed in a FortiGate-5140 chassis this is the lower handle.
To reset a FortiGate-5001A without removing the board from the chassis
You do not have to loosen the retention screws or adjust the position of the
FortiGate-5001A board to use this procedure.
To complete this procedure, you need:
• An ATCA chassis with a FortiGate-5001A board installed
• An electrostatic discharge (ESD) preventive wrist strap with connection cord
Resetting a FortiGate-5001A board
Alignment Pin
Handle
Alignment Pin
Handle
Fully Closed
and Locked
17