Hardware Installation - Fortinet FortiGate FortiGate-5001A Security System Manual

Hardware installation

Hardware installation
FortiGate-5001A Security System Guide
01-30000-0438-200800801
Before use, the FortiGate-5001A board must be correctly inserted into an
Advanced Telecommunications Computing Architecture (ACTA) chassis such as
the FortiGate-5140, FortiGate-5050, or FortiGate-5020 chassis.
Before inserting the board into a chassis you should make sure the SW-11 switch
is set correctly.
In the available Advanced Mezzanine Card (AMC) double-width opening on the
FortiGate-5001A-DW front panel you can install a supported FortiGate ADM
module such as the FortiGate-ADM-XB2 or the FortiGate-ADM-FB8.
Caution: Because the FortiGate-5001A board does not support hot swapping AMC
modules, the FortiGate-5001A board must be disconnected from power and the left handle
opened before you install a FortiGate AMC module. See
modules" on page 19.
Caution: Do not operate the FortiGate-5001A board with an open AMC opening. For
optimum cooling performance and safety, the AMC opening must contain an AMC slot filler
or a FortiGate AMC module.
This section describes:
• Changing FortiGate-5001A SW11 switch settings
• FortiGate-5001A mounting components
• Inserting a FortiGate-5001A board
• Removing a FortiGate-5001A board
• Resetting a FortiGate-5001A board
• Installing and removing AMC modules
• Troubleshooting
"Installing and removing AMC
9