Table of Contents
Advertisement
6
EN
4. MACHINE ASSEMBLY
PACKAGING CONTENTS
The packaging contains:
– power unit,
– bar,
– chain,
– bar cover,
– bag containing documents.
IMPORTANT
with the bar and chain dismantled and the oil tank
empty.
WARNING!
ing the assembly should be done on a flat
and sta ble surface, with enough space for
ma chi ne handling and its packaging, always
making use of suitable equipment.
Disposal of the packaging should be done in
ac cordance with the local regulations in for ce.
BAR AND CHAIN MOUNTING
WARNING!
gloves when handling the bar and chain.
Mount the bar and chain very carefully so as
not to impair the safety and efficiency of the
m achine. If in doubt, contact your dealer.
Before fitting the bar, make sure the chain brake is
not engaged; this is done by pulling the front hand
guard right back towards the body of the machine.
WARNING!
not plugged into the mains socket.
• MACHINES WITH STANDARD
CHAIN TENSION ADJUSTER
– Unscrew the handle (1) and remove the guard
to get to the drive sprocket and the point where
the bar is fitted (Fig. 1).
– Mount the chain in the right direction on the bar
(2). If the tip of the bar has a nose sprocket,
make sure the drive links are correctly inserted
in the sprocket rims (Fig. 2).
The machine is supplied
Unpacking and complet-
Always wear heavy-duty
Make sure the machine is
– Mount the bar (3) by inserting the stud bolt in
the groove and push it towards the back of the
machine body and wind the chain around the
drive sprocket (Fig. 3).
– Fit the guard back on without tightening the han-
dle (1).
– Check that the chain tension adjuster pin (4) in
the guard is fitted properly in the hole on the bar
(Fig. 5); if it isn't, turn the chain tension adjuster
screw (5) using a screwdriver until the pin is
comple tely inserted (Fig. 6).
– Turn the chain tension adjuster screw (5) to ad-
just the chain tension (Fig. 6).
– Raise the bar and tighten the handle (1) securely
(Fig. 7).
• MACHINES WITH QUICK CHAIN TENSION
ADJUSTER
– Unscrew the handle (11) and remove the
guard to get to the drive sprocket and the point
where the bar is fitted (Fig. 1A).
– Mount the chain in the right direction on the bar.
If the tip of the bar has a nose sprocket, make
sure the drive links are correctly inserted in the
sprocket rims (Fig. 2).
– Mount the bar (3) inserting the stud bolt in the
bar's slot using the tension adjuster (12); move
the bar towards the back of the machine body
(Fig. 3A).
– Wind the chain around the drive sprocket (13)
and push the bar forward to achieve an initial
tensioning of the chain (Fig. 4A).
– Fit the guard back on without tightening the han-
dle (Fig. 5).
– Turn the ring-nut (14) to obtain the desired chain
tension level (Fig. 6A).
– Raise the bar and tighten the handle (11)
securely (Fig. 7A).
MACHINE ASSEMBLY
Advertisement
Table of Contents
