Machine Assembly - Stiga Chain-saw Operator's Manual

Table of Contents

Advertisement

6
EN

4. MACHINE ASSEMBLY

IMPORTANT
The machine is supplied with
the bar and chain dismantled and the oil and fuel
tanks empty.
WARNING!
!
gloves when handling the bar and chain.
Mount the bar and chain very carefully so as
not to impair the safety and efficiency of the
machine. If in doubt, contact your dealer.
NOTE
The machine can be assem-
bled in different ways, depending on the bar fas-
tening system and the chain tensioning mecha-
nism.
Before fitting the bar, make sure the chain brake
is not engaged; this is done by pulling the front
hand guard right back towards the body of the
machine.
1a. MACHINES WITH STANDARD CHAIN
TENSION ADJUSTER
– Unscrew the nuts and remove the clutch cover
to get to the drive sprocket and point where
the bar is to be fitted (Fig. 1).
– Mount the bar (2) by inserting the stud bolts in
the groove and push it towards the back of the
machine body (Fig. 2).
– Mount the chain in the right direction around
the drive sprocket and along the bar rail (Fig.
3). If the tip of the bar has a nose sprocket,
make sure the drive links fit correctly in the
sprocket rims.
– Check that the chain tension adjuster pin (3) is
fitted properly in the hole on the bar (Fig. 4); if
it isn't, turn the chain tension adjuster screw
(4) using a screwdriver until the pin is com-
pletely inserted (Fig. 5).
– Fit the guard back on without tightening the
nuts. In models P 36(x) - P 37(x) - P 39(x) - P
41(x), check that the pin (1 - Fig.1) is inserted
correctly.
Always wear heavy-duty
– Turn the chain tension adjuster screw (4) to
adjust the chain tension (Fig. 5). Models P
44(x) and P 48(x) have another tension
adjuster between the guard nuts (5 - Fig. 5).
– Raise the bar and tighten the guard nuts
securely using the wrench (Fig. 6).
1b. MACHINES WITH "Q-TENS" QUICK
CHAIN TENSION ADJUSTER
– Unscrew the knob (1) and remove the clutch
cover to get to the drive sprocket and the
point where the bar is fitted (Fig. 7).
– Push the chain tension adjuster lock on the
bar (2) forwards as far as it goes (Fig. 8).
– Mount the chain in the right direction on the
bar (Fig. 8). If the tip of the bar has a nose
sprocket, make sure the drive links are cor-
rectly inserted in the sprocket rims.
– Insert the bar (3) and wind the chain around
the drive sprocket (Fig. 8).
– Rotate the outer ring (4) on the cover to line up
its pointer with the one on the guard (Fig. 9).
– Fit the cover back on by screwing the knob (1)
but not tight (Fig. 10).
– Tighten the chain by rotating the outer ring (4)
clockwise (Fig. 10).
– Raise the bar and tighten the knob (1) secure-
ly (Fig. 10).
2. CHECKS AFTER MOUNTING THE BAR
AND THE CHAIN
– Check the chain tension. The tension is cor-
rect when the drive links do not slip out of the
chain guides if you hold the chain in the mid-
dle of the bar (Fig. 1).
– Using a screwdriver, make the chain run along
the guides to check it moves smoothly without
resistance.
MACHINE ASSEMBLY

Advertisement

Table of Contents
loading

Table of Contents