Getting Started - FoodSaver V1090 Quick Start Manual

Getting Started

How to Make a Bag from a FoodSaver Roll
Place Bag on Sealing Strip
Cut enough bag material from roll to hold item
1.
to be vacuum packaged, plus 3 inches. Be sure to
cut straight.
2. Open appliance lid and place one end of bag
material across Sealing Strip
rubber gasket .
(J)
3. Close lid.
Turn Seal Control Switch
4.
How to Vacuum Package with FoodSaver Bags
Place Bag in Vacuum Channel
1. Place item(s) in bag, allowing at least 3 inches of
space between bag contents and top of bag.
Open appliance lid and place open end of bag
2.
down into Vacuum Channel
Close lid.
3.
Turn Seal Control Switch
4.
for vacuum and seal.
1
to vacuum and extended seal (for moist or
2
juicy foods such as raw meat).
Registering your appliance is quick and easy at www.foodsaver.com.
Set Seal Control Switch
, not over
(H)
to .
(E)
1
Set Seal Control Switch
(G) .
to:
(E)
Press and Release Lid
Press down firmly on lid with both hands until
5.
motor starts, wait 3-5 seconds, then release.
Motor will continue to run.
6. When motor and Indicator Light
press Open/Cancel Button
remove bag.
Now you are ready to vacuum package with your
new bag (see below).
Press and Release Lid
5. To begin vacuum process, press down firmly on lid
with both hands until motor starts, wait 3-5 seconds,
then release. Motor will continue to run.
6. When motor and Indicator Light
Open/Cancel Button
bag. Refrigerate or freeze if needed. (See FoodSaver
Reference Guide for food safety tips.)
Let appliance cool down for 20 seconds
Note:
after each use.
(A) turn off,
to open lid and
(B)
(A) turn off, press
to open lid and remove
(B)