Fingerprint Reader Assembly - HP ZBook 14U G5 Maintenance And Service Manual

Fingerprint reader assembly

Description
Fingerprint reader assembly (includes cable)
Before removing the fingerprint reader assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the fingerprint reader assembly:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the fingerprint reader bracket to the computer.
2. Lift the bracket from atop the fingerprint reader assembly (2).
3. Use a tool to pry the fingerprint reader board free from the computer (3), and then remove the assembly
from the computer (4).
Reverse this procedure to install the fingerprint reader assembly.
Bottom cover on page
Battery on page 49).
36).
Component replacement procedures
Spare part number
L15537-001
59