Table of Contents
Advertisement
Troubleshooting
WARNING
To reduce the risk of electric shock, turn power switch o and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
Problem
Possible causes
The powerbrush power switch
is turned off.
PowerBrush
Vacuum is locked in upright
doesn't
position.
rotate
Powerbrush has lodged debris or
other entanglements, keeping the
brush from rotating.
Filters are dirty.
The main hose is not connected.
Vacuum
There is a crack or hole in the
won't pick
main hose.
up dirt
The triple action brush roll bristles
are worn.
There is a clog in the vacuum.
The dirt container is not seated
correctly.
The dirt container is full.
Filters are missing.
Dirt is
escaping
from the
The dirt container is not seated
vacuum
properly.
Parts & Supplies
For Parts and Supplies, go to www.BISSELL.ca and enter
your model number in the search fi eld.
10
www.BISSELL.ca
Remedies
Make sure powerbrush switch is on.
Recline vacuum and switch on the
powerbrush.
Check the powerbrush and
remove debris.
Rinse pre-motor filter and tap dust
from post-motor filter. Allow enough
time for pre-motor filter to dry
properly before reinserting.
Locate the main hose and reconnect
by pushing the hose connection to
secure the latch.
If there is a crack or hole, order a new
main hose from www.bissell.ca
Replace the triple action brush roll.
Remove debris and any other
entanglements that may be
restricting its rotation.
Press the empty button to release the
dirt container and reseat properly.
Empty the dirt container.
Check to see if all of the pre-motor
and post-motor filters are in place.
If needed, order replacement filters
from www.bissell.ca
Press the empty button and remove the
dirt container. Insert the bottom first
and pivot the dirt container towards the
vacuum. Listen for a "click" sound, indi-
cating that it snapped into place.
Advertisement
Table of Contents
