Bissell POWERGLIDE PET 2215 Series User Manual page 9

Replace Brush & Belt
WARNING
To reduce the risk of electrical shock, turn power switch o and disconnect polarized plug
from electrical outlet before performing maintenance or troubleshooting checks.
Unplug and
1
turn vacuum
over. Unscrew
7 Phillips head
screws to
remove cover.
3
Inspect brush roll
by placing it on its
end and spin. The
brush roll should
spin freely, multiple
times by one flick.
If it doesn't, replace
brush roll. Inspect
belt, replace if
damaged.
Maintain the Pet TurboEraser
1
Twist gray collar counter-
clockwise, until slot appears,
and then separate faceplate.
3
To reassemble, align
two clips on each end
of paddle wheel with
belt on and pop back
into place.
Replace brush roll
with belt, making sure
all parts are aligned
correctly.
2
Pull roller straight out and slide belt off
motor gear. Replace roller and/or belt.
4
Pinching belt around brush roll and
hook back around the motor gear.
Rotate brush roll into place and line
up end caps to reinsert into vacuum.
Re-attach bottom cover with 7 screws.
Tool
®
Paddle Wheel
2
Remove brush roll,
belt, and paddle
Belt wheel. Inspect
for damages and
Roller
replace if necessary.
4
To put faceplate
back on, align the
tabs in the top of
the cover and place
it down to "click"
into place.
www.BISSELL.ca 9