Startup Time Of Printer Is Long - Oki C301 Maintenance Manual

Oki Data CONFIDENTIAL
(2-3) Bad odor is generated
Check item
(2-3-1) Bad odor locating
Fuser unit Remove the fuser unit and check the odor.
Low voltage power Remove the low voltage power supply unit and
supply unit check the odor.
(2-3-2) Fuser unit check
Life count of fuser Check the life count of the fuser unit by using
unit the self-diagnostic mode.
Check that no Check that no foreign materials such as paper
foreign material are stuck inside of the fuser unit.
exists in fuser unit.
44951501TH Rev.2
Check operation Actions for NG
results
Implement
section (2-3-2).
Replace the low
voltage power
supply unit
The fuser close
to the new fuser
unit smells
some odors.
Remove the
foreign material.

(2-4) Startup time of printer is long

Check item
(2-4-1) Fuser unit check
 
C heck that 100V is shownon the label on the
Halogen lamp
rearofthefuserunit.
(2-4-2) Option part check (note)
Extension memory Reinstall the option part (the extension
memory) and check operation.
SD memory card Reinstall the option part (the SD memory
card) and check operation.
Note! When the printer has a problem, for example it does not start properly, remove
any CU options (RAM and SD memory card) and check for changes.
7. TROUBLESHOOTING
Check operation Actions for NG
results
Replace the
fuser unit.
Replace the
option part.
Replace the
option part.
7-28