Address Programming; Communication And Report Programming; Receiver Programming - Bosch AMAX 2100 Installation Manual

110 en | Address Programming
8

Address Programming

With a LED/LCD keypad it is mandatory to use address programming.
With a text keypad both address programming and installer menu programming are possible.
Programming with keypad is possible only when all of zones in the system are in disarmed
status and no alarm is activated. The installer code is required for programming.
The control panel programming options are stored in a non-volatile flash memory. This
memory has all relevant configuration and user-specific data even after a total power loss.
Because the data retention time is quite long without power, reprogramming is not required
after powering up the control panel.
Notice!
It is not recommended to use other keypads or methods simultaneously to program the
system while programming with the current keypad.
The following chapters show an overview of all relevant programming options and their
addresses according to the descriptions in the chapter Settings, page 34.
8.1

Communication and Report Programming

8.1.1

Receiver Programming

The following table shows how to program the numbers, keys, and functions for a telephone
number via address programming or via installer menu programming.
Digit required
0 - 9
*
#
4 sec pause
Terminal
The following table shows how to program the numbers, keys, and functions for a subscriber
ID number via address programming or via installer menu programming.
Digit required
0 - 9
B
C
D
E
F
2015.05 | 06 | F.01U.309.277
Number to program via
address programming
0 - 9
11
12
13
15
Number to program via
address programming
0 - 9
11
12
13
14
15
Installation Manual
AMAX panel
Button to press via installer
menu programming
0 - 9
* 1
* 2
* 3
Not required
Button to press via installer
menu programming
0 - 9
* 1
* 2
* 3
* 4
* 5
Bosch Sicherheitssysteme GmbH